Introducing the complete Stealth HEI conversion kit.
this is a complete plug and play kit to convert your factory Chrysler electronic ignition into a powerful HEI igniton and eliminate the ballst resistor!
Included in this kit are the following:
1x 3d printed ignition box with heat set inserts installed
3x m4x10 bolts
2x m4x25 bolts
1x 3/8" thick laser cut 5052 aluminum heat sink.
1x Wiring Harnes with soldered 90* flag terminals for module, coil and distributor hookup. ground wire and jumper wire for ballast also included. Factory length 36"
1x wiring diagram.
1x Pertronix flame thrower 3 low ohm coil.
1x MADE IN THE USA Davis unified ignition HEI Module.
this coil and module cost $140 on there own!
This box bolts directly in place of the factory Chrysler ignition box, hiding the supplied GM 4 pin ignition module inside along with a 3/8" thick 5052 aluminum heat sink. Then switch out your factory canister coil for the included pertronix and jump the ballast resistor with the included jumper wire, plug in the distrubator and add the power wire to the coil from the jumped resistor wire and your off!
Everything pictured is included and free shipping!
